U1000MKII-FM-WM Clamp-on Flow Meter with Wall Mounted Keypad & Display
The New ULTRAFLO U1000MKII-FM-WM is a Clamp-on, Ultrasonic flow meter with a separate wall mounted keypad and display, a “Best Value” alternative to traditional in-line flow meters, for commercial and industrial water flow measurement applications. Offering significant installation cost and dry maintenance benefits over traditional in-line products.
Key Features & Benefits:
New: Clamp-on pipe mounted sensors with Wall Mounted keypad and display for wall or panel mounting
New: larger pipe range Available in 2 options. 22mm – 115mm OD and 125mm – 225mm OD
New: Optional Modbus RTU slave, RS485 serial and M-Bus communication.
New: Ultrasonic, cross-correlation transit time method for flow measurement.
New: 1Mhz transducers to get through poor/old thick wall pipes and larger pipework
New: Water/Glycol option
Simple to install: connect power and enter the pipe inside diameter, adjust the sensors and clamp-on the pipe, no specialist skills or tools required
A clamp-on non-invasive alternative to traditional in-line meter installation, plus dry servicing, providing minimum downtime and maximum availability.
LCD with backlight – install & service information.
Integrated pulse and optional 4-20mA output – aM&T & BEM’s compatible with Modbus.
Measurement Technique: Utrasonic, cross-correlation transit time method for flow measurement. Turn Down Ratio: 100:1 Accuracy: ±3% of flow reading for velocity rate >0.3 m/s (>1 ft/s) Flow Velocity Range: 0.1 to 10m/s (0.3ft/s – 32ft/s), Pipe Range: 25mm – 115mm OD and 125mm – 225mm OD. Note pipe size is dependent on pipe material and internal diameter. Pipe Material: Steel, Stainless Steel, Plastic and Copper Water Temp Range: 0°C – 135°C (32°F – 275°F). Pulse Output: Pulse or Frequency. Pulse for volume flow and alarms. Frequency for flow rate. The pulse output can be configured as loss of signal or low flow alarm. Opto-isolated MOSFET volt free contact [NO/NC]. 4-20mA Output: Optional 4-20mA flow proportional output. Resolution 0.1% of full scale. Maximum load 620Ω. Modbus Communication: Optional Modbus RTU slave, RS485 serial link hardware layer. Physical connection RS485. External Power Supply: 12V-24V +/- 10% AC/DC at 7 watts. Optional plug in 12V power supply Electronics Enclosure: IP68. Wall Mounted Keypad and Display Dimensions: 215mm x 125mm x 90mm [8.46″ x 4.92″ x 3.54″].